Power nozzle

MOTORS
for most popular vacuum power heads

long shaft fit-all motor 1 1/4"

fits almost all popular vacuums,
including MOST built-ins,
using the 2 top mount screw holes
(either 8x32" or 8x 24")
 OR the corner mount holes.
       
short shaft fit-all motor 7/8"
same as above but fits Hoover, Filter Queen, G.E. etc
using the 2 top mount screw holes
(either 8x32" or 8x 24")
 OR the corner mount holes.

BEAM geared belt only
power nozzle motor (for built-in)
Eureka newer style pn motor.
Uses metal strap as hold down.
older models use fit-all long shaft motor.
Hoover Futura, spectrum etc newer vacuums
w/ 3 screw mount design.
 
Uses short shaft fit-all motor w/ addaptor.
Better and much cheeper than original
 
Hoover older vacuums
w/ single side  screw mount design.
 
Uses short shaft fit-all motor w/ addaptor.
Better and much cheeper than origina
Kenmore Geared belt design.
*note-
this motor IS repairable if noisy.
front bearing (608zz) is available.
Lindhaus Geared or flat belt design motor. This motor is also repairable which is a good thing as a new motor is over $100.00 front bearing (626RS) is available.
Electrolux ap style pn motor.
w/circuit breaker and uses 3 screw mounting.
Electrolux newer style pn motor. uses 2 screw mounting.
Rexair/rainbow pn motor
fits newer pns only.
If your belt runs in the center of the roller brush this is your motor.
Older models use fit-all long shaft motor.
SEBO power nozzle motor.
price? don't ask!
OK ask, but please be sitting down.